Appendix A: Navdata ® And User Data Card Use - Garmin 300XL Pilot's Manual And Reference

APPENDIX
NAVDATA CARD
A
Saving User Data
Insert the card with the thumb tab at the top, and
the beveled corner on the bottom right.
Data card warning
112
Appendix A
NavData and User Data Installation/Operation
®
The NavData card supplied with your GNC 300XL can be installed or removed
when the GNC 300XL is on or off. Insert the card with the thumb tab at the top, and
the beveled corner at the bottom. If the NavData card is not present when the unit is
powered on, you will receive a 'No Jeppesen database' message on the database con-
firmation page, and you will only be able to use user waypoints for navigation. If the
NavData card is removed during operation, a 'No data card present' warning will
appear, asking you to reinsert the data card within 30 seconds. If the card is not
replaced within 30 seconds, the GNC 300XL will automatically reinitialize. You may
also reinitialize the unit manually by pressing E.
An optional user data card can be used to make a backup of user waypoints,
routes, etc. and/or transfer information to another GNC 300XL.
To save user data to the user data card:
1. Install the user data card.
O
2. Rotate to highlight 'Save user data?'. Press
The message 'Saving to card' is displayed while the GNC 300XL transfers all user
data to the User Data card. It may take a few minutes to complete the transfer. When
all user data is transferred, the GNC 300XL will instruct you to turn the unit off,
remove the user card and insert the Jeppesen NavData card. After this is complete,
the GNC 300XL is ready for normal operation.
E
to confirm.