Garmin 300XL Pilot's Manual And Reference page 126

APPENDIX
SIMULATOR
C
Database confirmation page
Entering an initial position reference.
116
To enter an initial position reference by waypoint identifier:
O
1. Rotate to highlight the waypoint identifier field.
K O
2. Use and to spell out the identifier of the desired airport, navaid or user waypoint.
E
3. Press to confirm the identifier. The waypoint confirmation page will appear, display-
ing the waypoint's position.
E
4. Press to confirm the 'ok?' prompt.
The position page will now appear, and you may now use most of the GNC 300XL
navigation features for practice and planning. You'll also receive a 'Do not use for nav'
message to remind you that the simulator mode should never be used for actual navi-
gation. During simulator operation, you will be able to enter a ground speed from the
CDI page, and define a course to a destination from the direct-to confirmation page.
Altitude may only be entered by using the VNAV function available from the NAV
menu 1 page (see page 26).
To enter a ground speed from the CDI page:
N O
1. Press and rotate
C
2. Press twice to activate the cursor in the GPS window.
O
3. Rotate to highlight the ground speed field.
K O
4. Use and to enter the desired speed. Press
To exit the simulator mode, the GNC 300XL must be turned off by rotating the B
knob counterclockwise until the unit shuts down. All waypoints and routes created in
simulator mode will be retained in the GNC 300XL' s internal memory.
to display the CDI page.
E
to accept, and
C
to finish.