Power And Backlighting - Garmin GPSMAP 3006C Owner's Manual

Powering On/Off the GPSMAP 3006C/3010C
Learning the basic operations, before moving ahead to the features of the GPSMAP 3006C/3010C, is
essential. Many times throughout this manual you will be prompted to press a key. When instructed, press
and then release the key. If the key needs to be held down, the instructions will prompt you.
Turning the GPSMAP 3006C/3010C ON:
1. Hold the POWER ( ) key until the unit powers on, then release.
As the unit powers on, an Introduction page is displayed. After reading the Introduction page, press
ENTER when "I Agree" highlights in yellow to display the Map Page.
Adjusting the Backlight
The Backlight can be increased in steps to produce the right lighting for the situation. You may cycle
through three light settings; Highest, Selectable, and Lowest.
Adjusting the Backlight's 'Selectable' level:
1. Press the POWER ( ) key to activate the Backlight Adjustment Window.
2. To increase the selectable backlighting level, press the ARROW KEYPAD up.
3. To decrease the selectable backlighting level, press the ARROW KEYPAD down.
TIP:
After the Backlight Adjustment Window is activated, pressing the POWER key repeatedly cycles
through the backlight's three settings: Highest, Selectable, and Lowest.
Getting Started Getting Started

Power and Backlighting

Main Page Sequence
Welcome Screen
Highest
Selectable
Lowest
13 13