Usb Interface Troubleshooting - Garmin StreetPilot 2820 Owner's Manual

USB Interface Troubleshooting

Problem/Question
How do I know my StreetPilot is in
USB Mass Storage Mode?
My computer never senses that
the StreetPilot is connected.
I cannot find any drives named
"GARMIN" in my list of drives.
A message saying "Unsafe
Removal of Device" appears when
I unplug the USB cable.
StreetPilot 2820 Owner's Manual
When your StreetPilot is in USB Mass Storage Mode, a picture of a StreetPilot connected to a
computer is shown. Also, your computer should show a new Removable Disk Drive listed in My
Computer.
1. Unplug the USB cable from your computer.
2. Load the USB drivers to your computer. See
3. Plug the USB cable into your computer. Select USB Mass Storage.
Try the solution listed above.
If you have several network drives mapped on your computer, Windows may have trouble
assigning drive letters to your StreetPilot drives. Follow the steps on the
drive letters.
When you are ready to disconnect your StreetPilot from your computer, double-click the
or Eject icon in your system tray. Select "USB Mass Storage Device" and click Stop. Select
the StreetPilot drives and click OK. You can disconnect your StreetPilot from your computer now.
Solution/Answer
page 22.
A
PPENDIX
next page to assign your
Unplug
51