Warning And Tips; Mounting Locations - ADS P450.2 Owner's Manual

warnings and tips
Always disconnect the battery ground wire before doing any work on your vehicle. Reconnect the cable
only after the installation is complete and the wiring has been checked to make sure that there are no
problems. If your radio features a code type security system, be sure you know the code before
disconnecting the battery!
Your a/d/s/ PowerPlate™ should be installed in 12V negative ground vehicles only. Connection to other
types of electrical systems may cause damage to the vehicle or the amplifier. Wear Eye and Ear protection
when using power tools.
Before cutting or drilling carefully inspect the area to make sure there are no electrical wiring, fuel lines
or brake lines that could be damaged. Sometimes these components may be hidden between double-
walled panels, so be very careful.
Do not bypass or modify the fuses, or replace with one of a higher rating. The fuse should not fail under
normal operation. Repeated blowing indicates a problem with the amplifier or improper installation. An
additional power supply line fuse (not supplied) must be installed on the 12V supply line and located as
close as possible to the battery in order to protect the wire in the event of a short circuit.
Make sure the system is turned off when making or breaking any connections. Do not use your PowerPlate™
with speakers which have either terminal connected to the speaker frame or to the vehicle chassis.

mounting locations

Due to its low profile, there are many possible choices of mounting locations. Always mount the
PowerPlate™ in a place that protects it from the elements. In addition, mount the PowerPlate™ on a
stable, flat mounting surface. Whenever possible, pre-drill the mounting holes. Remember to check
behind the panel for hidden dangers in the form of hoses, fuel or brake lines or electrical wiring. Use a
marking pen or awl to mark the hole locations and pre-drill using a 1/8" bit.
Passenger compartment mounting
All PowerPlates™ have been designed with a low profile to make under
seat mounting possible. Regardless of where you choose to mount your
PowerPlate™ be sure to keep a minimum of 1" of clearance around the
amplifier for adequate airflow to prevent overheating.
Trunk compartment mounting
The most common mounting location is in the trunk or cargo
compartment. For optimum cooling, mount the PowerPlate™ chassis
vertically with the fins running vertically, or mount the PowerPlate™
horizontally with the fins pointing upward. Avoid horizontal mounting
locations with the fins pointing downward.
Also, locate the PowerPlate™ where it, and connections to it, will not be
damaged by cargo or tools, which may shift during vehicle operation.
Engine compartment mounting
Don't even think about it! The PowerPlate™ was not designed to endure
the harsh chemical and heat environment of the engine compartment.
Failure to obey this warning will void your warranty.
3