ADS P450.2 Owner's Manual page 17

multi-cross™ crossover configuration, cont'd
xover control 5/6 (P850.2) - The crossover section dedicated for
channels 5 & 6 are activated by depressing the switch next to the
frequency adjustment control. Both high-pass and low-pass crossovers
are infinitely adjustable from 45Hz to 5,000Hz. The high-pass and low-
pass sections may be combined to create a bandpass filter.
Note: When using both sections to create a bandpass filter, make sure you have selected a
low-pass frequency which is higher than the high-pass frequency!
xover control 7/8 - The crossover selection for channels 7&8 has three possibilities:
When the switch is the center position, channels 7 & 8 are filtered
through a 12dB per octave low-pass crossover that is infinitely variable
from 45Hz to 5,000Hz.
When the switch is in the right position, the crossover section of the amplifier
is bypassed. Channel 7 & 8 output is full range.
17
When the switch is in the left position, channels 7 & 8 receive signal from
the crossover output of channels 5 & 6.
Note: When the switch is in the left position, the output level is
controlled by the ch 5/6 level control.