Table of Contents
Advertisement
3. connect
remaining
wires
0
Connect the other wires to outer terminal block screws.
Tighten screws. Replace the terminal block cover on the back
of the dryer. Tighten strain relief nut. Now, go to "Venting
Requirements."
i.
Remove
center
screw
[j
,,,,
y/'
S-/
Remove center terminal block screw (B).
3=Wire Power Supply Cord Connection
Use where local codes permit connecting cabinet-ground
conductor
to neutral wire.
3-wire receptacle (NEMA
type 10-30R)
3-prong plug
Spade terminals with
upturned ends
Ring terminals
Connect neutral wire (white or center) (D) of power supply cord
under center terminal block screw (B). Tighten screw.
Connect remaining wires under outer terminal block screws.
Tighten screws. Finally, reinsert tab of terminal block cover
into slot of dryer rear panel. Tighten strain relief nut. Now,
go to "Venting Requirements."
15
Advertisement
Table of Contents
