Table of Contents
Advertisement
GETTING STARTED
VACATION OR EXTENDED
TIME WITHOUT USE
When you will not be using the ice maker for
an extended period of time, turn off the water
and power supply to the ice maker.
Check that the water supply lines are insulated
against freezing conditions. Ice formations in
the supply lines can increase water pressure
and cause damage to your ice maker or home.
Damage from freezing is not covered by the
warranty.
6 | GETTING STARTED
UNPACK THE ICE MAKER
WARNING
Excessive Weight Hazard
Use two or more people to move and install
ice maker.
Failure to do so can result in back or other
injury.
REMOVING PACKAGING MATERIALS
Uncrate the ice maker. Remove tape and glue
from your ice maker before using.
To remove any remaining tape or glue
from the exterior of the ice maker,
rub the area briskly with your thumb.
Tape or glue residue can also be easily
removed by rubbing a small amount of
liquid dish soap over the adhesive with
your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing
alcohol, flammable fluids, or abrasive
cleaners to remove tape or glue. Do not
use chlorine bleach on the stainless
steel surfaces of the ice maker. These
products can damage the surface of
your ice maker.
CLEANING BEFORE USE
After you remove all of the packaging materials,
clean the inside of your ice maker before using
it. For instructions on how to clean the ice
maker, refer to the cleaning instructions in the
"Ice Maker Care" section of Use and Care Guide.
OPTIONAL PERSONALIZATIONS
REVERSING THE DOOR
For instructions on how to reverse the door,
refer to the "Door Reversal" section.
CUSTOM PANEL INSTALLATION
For instructions on how to install a custom door
panel, refer to the "Custom Wood Door Panel"
section.
If you plan to install a custom overlay panel, you
will need to make the panel yourself or consult
a qualified cabinetmaker or carpenter.
IMPORTANT:
The thickness of the overlay panel must
be 3/4" (1.91 cm).
Overlay panel must not weigh more
than 8 lbs (3.62 kg).
Overlay panels weighing more than
recommended may cause damage to
your ice maker.
Countersink all the handle mounting
hardware.
Match wood grain direction with that of
adjacent cabinets.
Sand panel edges to provide a smooth
finish.
Use moisture sealer on both sides and
all edges of the panel to avoid damage
from moisture.
PARTS NEEDED:
Instructions, #8 x 1/2" pan head wood
screws (14)
Handle Kit (optional)
STAINLESS STEEL PANEL INSTALLATION
For instructions on how to install the Stainless
Steel Panel, refer to the instructions received
with the Stainless Steel Panel kit.
Advertisement
Table of Contents
