Cleaning And Care; Oven Interior - Miele H 5030 BM Operating And Installation Manual

Cleaning and care

,
Do not use a steam cleaner to
clean the appliance. The steam
could reach electrical components
and cause a short circuit.
Clean the oven interior, inside of the
door and door seal as soon as it has
cooled down. Waiting too long can
make cleaning unnecessarily
difficult and in some cases
impossible.
In certain circumstances, very heavy
soiling can even damage the
appliance.

Oven interior

,
The oven interior can get hot
during use. Danger of burning.
The oven interior is made from
stainless steel which has been treated
with a special finish called
PerfectClean. This finish has an
iridescent appearance. Perfect-Clean
surfaces have very good anti-stick
properties and are easy to clean.
However, it is important to clean the
surfaces each time the oven is used.
The surfaces will become harder to
clean and the anti-stick properties will
deteriorate if soiling is not removed
after each use and allowed to build-up
If the oven is used frequently without
being cleaned, it may become very
difficult or even impossible to get clean
again.
62
Normal soiling
Do not use too much water on the
cloth or sponge and do not let water
or any other substance find its way
into any openings.
Clean the surfaces with hot water and a
little washing-up liquid applied with a
well wrung-out soft sponge.
Cleaning is easier if a little washing-up
liquid is applied to the soiling and left to
soak in for a few minutes before
cleaning.
If necessary, the reverse of a non-scrat-
ching washing-up sponge can be used.
After cleaning, rinse thoroughly with
clean water. The water must run off the
surface easily. Any residual cleaning
agents will hinder this effect.
Heavy soiling
Allow the surfaces to cool down to room
temperature. Apply a proprietary oven
cleaning spray (such as from Miele's
CareCollection), and leave to take effect
for a maximum of ten minutes only.
When using the Original Miele oven
cleaner, the time stated on the packaging
can be slightly extended if needed.
If necessary, the scouring pad on the
back of a non-scratch washing-up
sponge or a soft nylon brush can be
used to loosen the soiling. Repeat the
process if necessary.
After cleaning, rinse thoroughly with
clean water and then dry thoroughly.
These cleaning tips will help to assure
that the surface is cleaned thoroughly
and remains undamaged.