Garmin 16-HVS Instruction Manual page 15

Appendix A. CR23X/CR10X Programs
Port Serial I/O (P15)
1: 1
2: 61
3: 1
4: 5
5: 1
6: 0
7: 42
8: 100
9: 80
10: 1
11: 1
12: 0
8: Port Serial I/O (P15)
1: 1
2: 61
3: 1
4: 1
5: 1
6: 0
7: 42
8: 100
9: 80
10: 1
11: 1.0
12: 0.0
A-2
11 1 Multiplier, always 1.
12 0 Offset, always 0.
P15 parameters 4, 5, and 10 are somewhat variable. When using a CR23X,
parameter 4 can be set to 05, 06 or 07 depending on what control ports are
used. A CR10X can use control ports 1 through 6. Wiring of the
communication cable depends on the selection for parameter 4. With a CR23X
the GPS transmit wire is connected to the control port selected in parameter 4.
With a CR10X, the GPS transmit wire is connected to the control port 1 higher
then the control port listed in parameter 4.
P15 is executed when the PPS signal drives control port 8 high. P15 will wait
until one of three conditions is met: the time-out listed in parameter 9 has
expired, the maximum number of characters in parameter 8 have been read, or
the termination character listed in parameter 7 has been read.
P15 parameter 10 is the first input location you wish to store GPS data in.
Fifteen sequential input locations will be used to store time and position.
Example A-1. Program Instruction 15 (P15) for CR23X
Reps
-- ASCII/RS-232, 1200 Baud, decimal delimiter
Delay (units = 0.01 sec)
Control Ports
Output Loc [ Bulk ]
No. of Locs to Send
Termination Character
Maximum Characters
Time Out Delay (units = 0.01 sec)
Loc [ Raw_time1 ]
Mult
Offset
Example A-2. Program Instruction 15 (P15) for CR10X
Reps
ASCII/RS-232, 1200 Baud, decimal delimiter
Delay (units = 0.01 sec)
First Control Port
Output Loc [ Bulk ]
No. of Locs to Send
Termination Character
Maximum Characters
Time Out Delay (units = 0.01 sec)
Loc [ Raw_time1 ]
Mult
Offset