Table of Contents
Advertisement
Quick Links
Appliances
Installation Instructions
Spacemaker ® Dishwasher
If you have questions,
call 800.GE.CARES
(800.432.2737}
or visit
our website
at: www.ge.com
BEFORE YOU BEGIN
Read these instructions
completely
and
carefullu.
IM PORTANT-
Observe all governing
codes
and ordinances.
• Note to Installer
- Be sure to leave these
instructions
for the consumer and local inspector's
use.
• Note to Consumer - Keep these instructions with
your Owner's Manual for future reference.
• Skill Level-
Installation
of this dishwasher requires
basic mechanical,
electrical and plumbing skills.
Proper installation
is the responsibility
of
the installer.
Product failure due to improper
installation
is not covered under the GE
Appliance
Warranty.
See warranty
information.
• Completion
Time - I to 3 Hours. New installations
require more time than replacement
installations.
• Sink Requirement
- This Spacemaker _ dishwasher
is designed to be installed under a special shallow
sink. Three types of sinks are available: GPF95, a
single bowl sink with the drain hole on the right
side of the sink; GPF96, a single bowl sink with the
drain hole on the left side of the sink; and GPF97, a
double bowl sink. Purchase these sinks from your
authorized GE appliance dealer.
IM PORTANT-
The dishwasher
MUST be
installed
to allow for future removal from the
enclosure
if service is required.
If you received a damaged
dishwasher,
you should
immediately
contact
your dealer or builder.
Optional Accessories - See the Owner's Manual for
available custom panel kits.
FOR YOUR SAFETY
Read and observe all CAUTIONS and WARNINGS
shown throughout these instructions. While
performing installations describedinthisbooklet,
glovesand safetgglassesshould be worn.
READ CAREFULLY.
KEEP THESE INSTRUCTIONS.
Advertisement
Table of Contents
Related Manuals for GE GSM2200N10BB
Summary of Contents for GE GSM2200N10BB
- Page 1 Proper installation is the responsibility performing installations describedinthisbooklet, the installer. Product failure due to improper glovesand safetgglassesshould be worn. installation is not covered under the GE Appliance Warranty. See warranty information. • Completion Time - I to 3 Hours. New installations require more time than replacement installations.
-
Page 2: Materials You Will Need
PARTS SUPPLIED IN INSTALLATION Screw Kit PACKAGE: Phillips Head Hex Head [] Two 8-18 x 5/8" Phillips head wood screws _'_ Wood Screws Junction Box Screw [] Junction box cover and #10 hex head 5/8" long 112" long Junction Box Cover screw Drain hose (78"... -
Page 3: Installation
Installation Preparation-Enclosure • Sink opening for garbage disposer must be PREPARE DISHWASHER ENCLOSURE dimensioned as shown (7-1/2")in Area "C." This will SINK LOCATION provide clearance for disposer and plumbing in • Water line to sink faucet and drain from sink can Area "C"... -
Page 4: Prepare Drain Plumbing
Installation Preparation-Drain METHOD 1-Air Gap with Waste Tee or Disposer PREPARE DRAIN PLUMBING Drain Requirements • Followlocal codes and ordinances. • Drainhose must notexceed 10 feetinlength, • A highdrainloopor airgap isrequired. See below. Drain Method Figure C The type of drain installation depends on the Waste Tee Installation Disposer... -
Page 5: Prepare Electrical Wiring
Installation Preparation-Electrical Supply PREPARE ELECTRICAL WIRING Alternate FOR PERSONAL SAFETY: Remove house Receptacle fuse or open circuit breaker before Location beginning installation. Do not use an extension cord or adapter plug with this appliance. fro m Cabinet Electrical Requirements Receptacle •... - Page 6 Installation Preparation-Hot Water Supplg PREPARE HOT WATER SUPPLY CAUTION Hot Water Line • The line may enter from either side, rear, or floor The hot water supplg line pressure must be at least 20 PSI. Lower pressures could cause the water valve to leak and within the shaded area shown in Figure F.
-
Page 7: Dishwasher Installation
Dishwasher Installation STEP 3: REMOVE WOOD BASE CAUTION IM PORTANT - Donot kick off wood base! Do not remove the wood base until are ready Damage will occur. to install the dishwasher. The dishwasher will tip over when the door is opened if the base is removed. Move the dishwasher close to the installation location and lay it on its back. - Page 8 National Electrical Code, Section 422 and/ or local codes and ordinances. Maximum power cord length is 6 feet. Power Cord Kit WX09X70910 Bracket available for purchase from an authorized GE Red Electrical 90 ° Elbow Connection Appliance Dealer, meets these requirements.
- Page 9 The GPF65 kit is available from authorized GE appliance dealers. • Refer to Figure P and follow the instructions included in Side- Mounting_ the kit.
-
Page 10: Step 11: Slide Dishwasher
Dishwasher Installation STEP 12: POSITION AND LEVEL STEP 11: SLIDE DISHWASHER INTO CABINET DISHWASHER IM PORTANT - Do not push against the front IMPORTANT- Dishwasher must be level for panel with knees. Damage will occur. proper dish reck operation, wash performance, and door operation. - Page 11 Dishwasher Installation STEP 13: FASTEN DISHWASHER STEP 14: CONNECT WATER SUPPLY UNDERSIDE OF COUNTERTOP OR SIDES Connect the water supply line to the 90° elbow OF CABINET installed in Step 6. • Slide the compression nut and then the ferrule over In this step you will need the two 5/8"...
-
Page 12: Drain Line
Dishwasher Installation STEP 15: CONNECT DRAIN LINE Method I - Air gap with waste tee or disposer The molded end of the drain hose will fit 5/8" r¢ through 1" diameter inlet ports on the air gap, waste tee or disposer. •... - Page 13 Dishwasher Installation STEP 16: CONNECT POWER SUPPLY STEP 17: INSTALL JUNCTION BOX COVER Ifa power cord with plug is alreadg installed, If junction box cover is alreadg installed, skip to proceed to Step 17. Step 18. In this step gou will need the junction box cover and If house wiring is not 2-wire with a ground...
- Page 14 Dishwasher Installation - Check the electrical connection to the water STEP 19: DISHWASHER WET TEST valve. The red electrical connector should be CHECK LIST plugged into the dishwasher water valve. If it is [] Turn on power supplg or if power cord is used, not plugged in, turn off electrical power to the plug it into the wall outlet.
- Page 15 Dishwasher Installation STEP 20: REPLACE ACCESS PANEL AND STEP 21: LITERATURE TOEKICK [] Leave the Owners' Hanual, Installation In this step gou will need the panels and the two Instructions, samples, and/or coupons with consumer. screws set aside in Step 4. There are two tgpes of screws used.
- Page 16 SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE GE Consumer & Industrial General Electric Company Pub. No.31-30219 Louisville, Kentucky 40225 Dwg.No.206CI559PI59 ND 06M-2101(i/07) ge.com...