Adjusting The Drive Cable - Murray M2255FC Instructions Manual

Maintenance (Continued}
Adjusting the Drive Cable
(SeifoPropeiled Units Only)
WARNING:Before you adjus_ the drive cable,
release the engine stop lever and wai_ for the
engine to stop.
if the drive system does not engage and disengage correctly,
check the handle for correct assembly, Make sure that all
parts are in good condition, not broken or bent, and that all
fasteners are tight_
Worn parts and cable stretch will change the performance of
the drive system_When you mow in high or thick grass or
on hills, the drive system can slip, if the drive system is
slipping, adjust as follows or take the mower to an
authorized service center,
iMPORTANT:Before you start the engine, operate the engine
stop lever several times, Make sure the engine stop cable
moves freely,
Note: Theengine design does not include a throttle control
or an engine speed adjustment. Theengine is set at the best
speed for cutting grass, bagging grass, and for extended
engine life.
1, if the drive system is slipping, turn the cable adjuster
(A, Figure 19) one turn in the direction shown. Testthe
drive system and check for slippage.
2. if the drive system stiff slips, turn the cable adjuster one
more turn to shorten the cable. Again, test the drive
system.
3. Repeatthe adjustment and test until the drive system
does not slip.
4. Beforeyou begin to mow, make sure the drive system
will correctly disengage and that the mower will stop. if
the drive system will not disengage, take the mower to
an authorized service center before you operatethe
mower,
Figure 19:Adjusting the drive cable
15