Kohler 12RESM1 Installation Manual page 25

Note: The generator set will not start and circuit board
damage may occur if the battery is connected in
reverse.
Figure 1-22 shows the location of the engine starting
battery. Standard battery cables provide easy
connection to the battery. Use the following procedure
to install and connect the battery.
1
1. Engine starting battery location
Figure 1-22 Battery Location, Air Intake End
TP-6516 4/09
Battery Installation Procedure
1. Ensure that the starting battery is fully charged
before placing the battery in service.
2. Clean the battery posts and/or adapters if
necessary.
3. Install the battery post adapters, if needed.
4. Place the battery in the housing.
5. Verify that the controller master switch is in the OFF
position.
6. Connect the positive (+) lead to the engine starting
battery.
7. Connect the negative (--) lead to the engine starting
battery.
Refer to the generator set Operation Manual and the
ADV-7341A-B
battery
maintenance instructions.
manufacturer's instructions
Section 1 Installation
for battery
25