dbx DriveRack Monitor Application Manual page 13

dbx
DriveRack™
Monitor Application Guide
Termination LEDs
These LEDS indicate when network is properly terminated. The Green LED indicates that the net-
work has been correctly terminated.
Remote Controller In Connection
This DB-9 type input connection is used to receive information from the 480 Remote DriveRack™
Unit.
Outputs 1-8 (Euroblock Connectors)
The output section of the 481 DriveRack™ offers eight electronically balanced Euroblock connec-
tors.
Inputs 1-4
The input section of the 481 DriveRack™ offers four electronically balanced Euroblock connectors.
Ground Lift Switch
This switch (when pressed in), is used to lift the Pin one ground on either inputs 1 or 2 or 3 or
4.
Front Panel (481)
RS232 Host Connection
This DB-9 type connection is used to send and receive information to and from the GUI interface.
Program Up and Down
These program up and down buttons are used to scroll through the program menu of the 481.
Program Display
This program display is used to indicate the currently selected program of the 481.
ID Display
This ID display is used to indicate the current assigned identification of the 481. This identifica-
tion is essential for unit recognition when the 481 is used in a network system.
Control Bus LED
This LED (when lit) indicates that the 481 is sending/receiving network information.
Remote LED
This LED (when lit) indicates that the 481 is sending/receiving from a 480R.
PC LED
®
13