Baby Lock Aria BLAR Instruction And Reference Manual page 45

e
Place the additional spool of thread on the
supplemental spool pin, so that the thread
unwinds from the front. Push the spool cap
onto the spool pin as far as possible to
secure the thread spool.
a Spool pin
b Spool cap
c Thread spool
f
Hold the thread from the spool with both
hands, and place the thread in the thread
guide.
* Do not place the thread in the pre-tension disks.
a Thread guide
g
While holding the thread from the spool,
pull the thread through the lower notch in
the thread guide plate, then through the
upper notch. Hold the end of the thread
with your left hand, and then guide the
thread through the groove, following the
arrows in the illustration.
h
Continue threading however do not pass
the thread in the needle bar thread guide
"6" on the needle bar. Thread the needle on
the right side.
a Needle bar thread guide
i
Press to unlock all keys and
buttons.
j
Select a stitch pattern. (Example:
* Refer to the "STITCH SETTING CHART" on
page S-68 for the proper stitch to use with presser
foot "J".
→ The selected stitch is displayed.
Note
• If the key is light gray after selecting
the stitch, the selected stitch cannot be
sewn in the twin needle mode.
k
Press to select the twin needle mode.
a
a Single needle/twin needle setting
→
appears.
CAUTION
• Be sure to set the twin needle mode when
using the twin needle. Using the twin needle
while the machine is in single needle mode
could cause the needle to break, resulting in
damage.
UPPER THREADING
)
Basic operations B-43
B
1