Basic Operation; Turning On The Power; Channel Selection - Icom IC-F5220D Insrtuction Manual

2

BASIC OPERATION

Turning ON the power

■
Push [ ] to turn ON the power.
q
If the transceiver is programmed for a start up password,
w
input the digit codes that were set by your dealer.
• The keys shown below can be used for password input:
The transceiver detects numbers in the same block as identical.
Therefore "01234" and "56789" are the same.
KEY
NUMBER
If the "PASSWORD" indication does not clear after input-
e
ting 6 digits, the input code number may be incorrect. Turn
OFF the power and re-enter your password.
6
0 1 2 3 4
5 6 7 8 9

Channel selection

■
There are several ways to select channels, and they may dif-
fer, depending on your system set up.
NON-ZONE TYPE:
To select the desired operating channel:
Push [CH Up] or [CH Down].
➥
Push one of [MR-CH 1] to [MR-CH 4].
➥
ZONE TYPE:
To select the desired operating channel:
Push [Zone], then push [CH Up] or [CH Down].
➥
VOTING OPERATION:
The transceiver automatically starts scanning when a zone,
specified for the voting operation, is selected.
The voting scan detects the S-meter of the repeater and au-
tomatically selects the strongest station.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
ON the power, the transceiver automatically starts scanning.
Scanning stops when a signal is detected.