I Call Channel Programming; I Channel Names - Icom IC-M503 Insrtuction Manual

I Call channel programming

The call channel switch can be programmed to your most
often-used channels in each channel group for quick recall.
q While pushing and holding [HI/LO], push [DIAL] one or
more times to select the desired channel group (Interna-
tional, U.S.A., Holland, ATIS, DSC) to be programmed.
w Push and hold [CALL] for 3 sec. to enter the call channel
programming condition.
• Channel number starts flashing.
e Rotate the channel selector to select the desired channel.
r Push [CALL] to program the displayed channel as the call
channel.
• Push [DIAL] to cancel the programming.
• The channel number stops flashing.

I Channel names

Memory channels can be tagged with alphanumeric names
of up to 10 characters each.
Capital letters, small letters, numerals, some symbols (! " # $
% & ' ( ) ✱ + , – . ⁄ ) and spaces can be used.
q Select the desired memory channel.
• Cancel dual watch, tri-watch or scan in advance.
w While pushing and holding [HI/LO], push [CALL] to edit the
memory channel name.
• A cursor appears and blinks.
ä
e Select the desired character by rotating the channel selec-
tor or by pushing [Y]/[Z] on the microphone.
• Push and hold [SCAN] or [DIAL] for cursor movement.
r Push [CALL] to input and set the name.
• The cursor disappears.
t Repeat steps q to r to program another memory channel
name, if desired.
3
BASIC OPERATION
9