Table of Contents
Advertisement
OPERATING INSTRUCTIONS continued...
Fan Speed Test
1. After selecting Fan Speed Test and pressing
"ENTER" (lower right blank), the control will turn
the oven fan on LOW speed for ten seconds. Verify
that the fan is indeed running on low speed. The
control will show:
2. After a short while, the control will turn the fan on
HIGH speed for ten seconds. Verify that the fan is
indeed on high.
3. After a few seconds, the test will complete. Press
"CANCEL" to return to Diagnostics Mode.
Heat Test
1. After selecting Heat Test and pressing "ENTER"
(lower right blank), the control will show the actual
temperature of the oven and will turn the heaters
on. Verify that the actual temperature increases
during the test.
2. After a short while, the test will complete. Press
"CANCEL" to return to Diagnostics Mode.
Page 12
Moisture Test
1. After selecting Moisture Test and pressing
"ENTER", the control will show the moisture
status as OFF for ten seconds.
2. The control will then turn moisture on for ten
seconds, verify that the moisture has actually
turned on within the oven by looking through the
glass door.
3. After a few seconds, the Moisture Test will complete.
Press "CANCEL" to return to Diagnostics Mode.
Temperature Calibration
1. After selecting Temperature Calibration and
pressing "ENTER", the display will show the
Actual Temperature inside the oven. Verify the
cavity temperature using a pyrometer.
• NOTE: If the oven temperature is below 200°F,
Temperature Calibration will not be active and the
display will show Low Temp.
2. Press and hold the "TEMP" (upper right blank)
button for three, (3), seconds. The display will
show the Actual Temperature on the first line and
Set Temperature on the second line. If the Actual
Part # 4518084 Rev. 1 (09/04)
Advertisement
Table of Contents
