LG WF-T10(~3)0(~2,6)1(~5)TP(H,E,F)(S,3) Service Manual page 50

11) Spining is going on even though the lid is open.
Where, what & how to check?
Safety Switch
1. Check resistance between both
terminals of the safety switch with
the lid open.
Ball Pressure Sensor
1. Is placed the magnetic on the wash?
12) Spin basket doesn't reach to full speed(normal rpm)
Where, what & how to check?
Main voltage
1. Check voltage at the power outlet
where the washer is plugged into.
Starting Capacitor
1. Check the capacitance of the
starting capacitor.
Clutch Assembling
1. Check the clearance between the
PV link and the brake lever and
clearance between the clutch lever
and the adjustment bolt.
Blocked by foreign objects
1. Check whether the PV asm, the
drain pump & the drain hose are
blocked by foreign objects so that it
makes water-splashing noise in the
tub.
Result of Check Possible Cause How to repair & settle
Contact points of
0~9Ω
the safety switch
are welded.
Defect of the
∞Ω
controller.
Reed S/W is short
by magnetic on
Yes
the washer.
Reed Switch.
No
Result of Check Possible Cause How to repair & settle
Tool low voltage
Less than
85% of rating
Lack of Defect of
capacitance capacitor
The clearance is
less than 2.0mm
or more than 3.5mm
Bolt clearance is Defect of the
out of range clutch
1.9±0.1mm
49
Change the Safety
Switch
Change the controller
Keep magnet away from
the washer.
Change the controller.
Explain the cause and
recommend using a
transfomerformer if
necessary.
Change the capacitor
Adjust PV lever bolt and
paint it red.
Reassemble the drain
motor or the clutch.
Adjust the bolt
clearance.
Remove the foreign
objects.