Connect The Drain Hose - LG WF-T10(~3)0(~2,6)1(~5)TP(H,E,F)(S,3) Service Manual

2-3. CONNECT THE DRAIN HOSE

■ For pump model
· Connect the drain hose to
the outlet of the drain pump
located at the rear of the
washing machine.
· NOTE
· Never lay down the drain hose, as water will be discharged.
:
· Be sure the drain hose is properly routed so it will not kink
or lift from the sink.
·The discharge height should be approximately 0.9~1.2m from
the floor.
·Connect the drain hose adjusting the length of it not to be
dropped. If drain hose is dropped the drainage could be poor
because of blockage in the hose.
■ For non - pump model
· Connect the drain hose to the outlet of the
drain located at the back side of the
washing machine.
·Keep it downward while the washing machine
is working.
·Ensure the hose is free from kinking.
·Do not install the washer where it is directly exposed to sunlight, wind, rain etc.
CAUTION
·Plug the power cord of this washer into a properly installed standard electrical outlet
that is switched & earthed.
·Attach the clip to the drain
hose. And then push it toward
the body of the washing
machine as indicated by the
arrow.
·Fix the drain hose with the clip.
And then push it toward the body as in the
figure.
9
·Check that the drain hose is
hung up over the edge of the
laundry tub.
·Do not use an extension hose.
Hose
Guide
0.9~1.2m
Drain Hose