Pace DC758D Operator's Manual page 18

MAKING USER SETTINGS (cont.)
Changing the TV Display Capability
The flow diagram (below) shows how you use the arrow and SELECT buttons on your set-top' s front panel to
change the display and make the settings. See also the instructions on pages 18 and 19.
SELECT
SELECT
SELECT
If you have not already done so, put your set-top into User Settings mode, as described on page 16.
1. Press the U or D button until the front panel shows "reS" (short for resolution). On the PACE USER
SETTINGS menu, TV Display Capability is highlighted when "reS" is on the front panel.
2. Press the R button when you see "reS" on the front panel.
The front panel shows the TV display capability that was last selected, so it could show 480i, 480P, 720P,
1080i, 1080p24*, or 1080p30* (the last three settings are displayed as 1080). The TV Display Capability
menu, shown right, appears on your TV screen.
If your HDTV is 1080p-compliant and connected by HDMI, setting "1080p24 Pass" to YES causes 1080p/24
transmissions (at 24 frames per second) to be displayed at 1080p/24. Likewise, setting "1080p30 Pass" to
YES causes 1080p/30 transmissions (at 30 frames per second) to be displayed at 1080p/30.
The HDMI-connected HDTV may report that it is not 1080p-compliant and set "1080p24 Pass" (or "1080p30
Pass") to NO. In this case 1080p transmissions will be output at one of the other resolutions (1080i, 720p,
480p, or 480i). If you override this NO setting and set YES, you may see nothing for 1080p transmissions.
If the HDTV is not connected by HDMI, "HDMI Cable Required" is displayed and you cannot set "1080p24
Pass" or "1080p30 Pass" to either YES or NO.
Transmissions at 480i, 480p, 720p, or 1080i can never be output at 1080p.
TV Display Capability
1080i : NO
720p : NO
480p : YES
480i : YES
1080p24 Pass : YES
1080p30 Pass : YES
SELECT
TV Display Capability
1080i : YES
720p : NO
480p : YES
480i : YES
1080p24 Pass : YES
1080p30 Pass : YES
* NOTE
DC758D OPERATOR'S MANUAL (501-3333200)
This diagram shows an example only.
Make sure that, for each resolution, you
select the correct setting (YES or NO) that
applies to your TV.
The on-screen
menu shows the
selected setting.
If the highlighted resolution is currently
set, the MESSAGE light is lighted and
YES is on the menu
TV Display Capability
1080i : YES
720p : NO
480p : YES
480i : YES
1080p24 Pass : YES
1080p30 Pass : YES
18