Jensen JTA-980 User Manual page 14

7. To cancel the programmed selections, press the PROGRAM button and then the "STOP
button until the "PROG "indicator disappears from LCD display.
Important Notices:
- Always press the "STOP
information before pressing the "OPEN/CLOSE
- Before opening the tray for either
"STOP" mode and you have deleted all programmed tracks.
- You must close the CD tray(s) (either
while operating.
PLAYING COMPACT DISCS IN CD-2
Press the "CD 2" function button on the unit front panel to select CD-2 mode, wait for the display to
show the "CD 2" indicator. The basic operation of CD-2 is same as
differences:
When No Disc is Loaded
- "No disc" message will be shown on display.
 Play/Pause Mode
- To temporarily stop playback, press the "PLAY/PAUSE
time will be stop on the LCD display. Press the " PLAY/PAUSE
to cancel pause and resume playback.
Skip Mode (Skip Up
- The system will go to the next or previous track only when you press the Skip button during
PLAY or PAUSE mode.
Random Play Mode (using the Remote Control)
- Press the RANDOM button at remote control to activate the shuffle play function and the
random indicator "RAN" will show on the LCD display. Press the "REPEAT" button once to
cancel the random play function.
CD Disc Programming (using the Remote Control)
- Up to 32 tracks can be programmed when using CD-2 .
- After a programmed played, you can delete the programmed tracks in the order from the last
one to the first one by pressing the "CLEAR " button on the remote control. This function allows
you to re-program the memory half way through if necessary.
Display Information (using the Remote Control)
- During CD playback, press the DISPLAY button to toggle between elapse time or time
remaining for the track being played.
Repeat Play Mode
Press the REPEAT button before or during playback, a single track or all the tracks can be played
in the following modes:
(1) Repeat All Tracks
Remarks:
- The CD burner reaction time is longer than a normal CD player. If you keep pressing buttons
while the CD burner is operating, you might cause a malfunction of the system. Please re-start
the unit if this is happen.
- The reading and playback time of some CD-R/RW discs vary from brand to brand.
" button to stop CD playback and return the LCD to the original
or CD-2, make sure the system is in the CD
or CD-2) before switching to other function mode
/Skip Down )
(2) Repeat 1 Track
13
" button for disc changing.
except for the following
" button once, the playing
(3) Off Mode
"
" button once more