HP XW8400 Manual page 40

3 Connecting System Components
not available for the Linux-based version of Lustre, since it uses Incinerator to obtain real-time
rendering and playback.
Although the Slave Renderer uses a network connection, a higher Category 6 grade cable is
needed to accommodate the data that is transmitted. For information on configuring the IP
addresses of the network ports that connect the two workstations, see the Autodesk Lustre 2009
Software Installation Guide for Windows Workstations.
To connect the Slave Renderer to a Windows-based workstation:
1. Connect the Category 6 crossover cable to the on-board network port at the back of the
Lustre workstation.
Connect the other end of the cable to the network port 1 of the Slave Renderer machine.
2.
The Slave Renderer should be connected as shown in the following diagram.
34