Using A Speakerphone - Cisco 7975G Software Manual

If you use AutoAnswer, see
Using a Wireless Headset
Cisco Unified IP Phones 7975G, 7965G, and 7945G support wireless headsets. Refer to the wireless
headset documentation for information about using the wireless headset's remote features. Also, check
with your system administrator to be sure your phone is enabled to use a wireless headset with the
wireless headset remote hookswitch control feature.
Using Wideband with your Headset
If you use a headset that supports wideband, you may experience improved audio sensitivity if you
enable the wideband setting on your phone (this setting is disabled by default). To access the setting,
choose > User Preferences > Audio Preferences > Wideband Headset.
If the Wideband Headset setting shows as dimmed, then this setting is not user controllable.
Check with your system administrator to be sure your phone system is configured to use wideband. If
the system is not configured for wideband, you may not detect any additional audio sensitivity even
when using a wideband headset. To learn more about your headset, refer to the headset documentation
or ask your system administrator for assistance.

Using a Speakerphone

Many of the actions you can take to dial a number or answer a call will automatically trigger
speakerphone mode, assuming that the handset is in its cradle and
If you want to...
Toggle speakerphone mode on
or off
Switch to a handset
Adjust the volume level for
a call
2
Using AutoAnswer with a Headset or Speakerphone, page
Then...
Press .
Lift the handset.
Press
Press Save to preserve the volume level for future calls.
is not lit.
during a call or after invoking a dial tone.
3.
OL-22332-01