Iid. Water Connection; Iie. Drain And Condensation Hose Connections - Kenmore 630.13952 Manual

INSTALLATION
IID. Water connection
Install according to national and local codes.
Carefully place dishwasher on its back to make water connections to the water inlet
valve. Use a 90º elbow fitting with Teflon tape as needed. Don't overtighten.
Attach the hot water line to the 90° elbow and route it underneath the unit toward the
hot water connection. Make sure the line doesn't contact any moving parts.
IIE. Drain and condensation hose connections
Plumbing installations will vary - refer to local codes. The maximum length of the drain
hose, including leading to an air gap (if any) is 150" (381 cm). Make sure a high loop
is raised at least 20" (51 cm) above the floor.
Drain hose has its own adapter – connect directly to plumbing connection and secure
with supplied hose clamp. Don't connect to condensation hose.
702_58300000149896_ara_en_b