Download Print this page

Drain Connection - Kenmore Elite 630.1399 Series Installation Manual

Hide thumbs Also See for Elite 630.1399 Series:

Advertisement

Available languages

Available languages

To connect the hot water supply:
1. Assemble the water supply adaptor fitting from the
parts bag onto the dishwasher water supply hose. This
connection does not require Teflon brand tape.
2. Pass the dishwasher water supply line with attached
adaptor through the opening toward the water shut off
valve. Take care not to allow the hose to kink or twist
behind the dishwasher.
3. Connect the dishwasher water supply line with adaptor
to the water shut off valve. You will need to use an
approved dishwasher water supply line with the correct
fittings for this connection. Always use the appropriate
seal when making plumbing connections.
NOTE: The end of the dishwasher water inlet hose is
heavy and will need to be supported. It is best to lay
the end on the cabinet floor.
4. After all connections are made, turn on the hot water
and check for leaks.
AY
WARNING
Avoid Scald Hazard
Do not perform any work on a charged hot water line.
Serious injury could result. Only qualified plumbers should
perform plumbing work. Do not attempt any work on
the dishwasher hot water supply plumbing until you are
certain the hot water supply is shut off.
DRAIN CONNECTIONS.
IMP
The
ORTANT NOTES:
If local ordinance require an air gap, install it according
to the manufacturer's instructions.
If the dishwasher
drain hose is to be connected
to a
disposer dishwasher drain connection, remove the plug
from the disposer's dishwasher drain connection.
The dishwasher drain hose must have one place along its
length that is securely attached 20 inches (50.8cm) above
the cabinet floor.
The drain hose length can be extended if necessary. The
maximum
length of the drain hose, including the hose
leading to the air gap, is 150 inches (381cm).
dishwasher drain hose may be connected to the
household or field drain plumbing in one of four ways. You
will
need a 1 f,
(3.2 cm) diameter hole in order to pass
the drain hose through the cabinet.
7
Directly to the undersink
Directly to a disposer
dishwasher drain connection.
dishwasher drain connection.
To the undersink dishwasher
To a disposer dishwasher
drain connection through an
drain connection through an
air gap.
air gap.

Advertisement

loading

This manual is also suitable for:

Elite 630.1300 seriesElite 630.1302 series