Delete Ip Filter; Delete Ip Filter All; Ip Filters; Active - HP MSM3xx Reference Manual

CLI commands

delete ip filter

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
delete ip filter <ip address>/<mask>
Deletes the specified address from the IP filter list.
If the list is empty, then all wireless-to-wired LAN traffic is permitted.
Where:
<address>
</mask>

delete ip filter all

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
delete ip filter all
Deletes all addresses from the IP filter list.

ip filters

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
ip filters
Activates the IP filter which enables you to block wireless-to-wired LAN traffic on this profile
based on its destination address.
no ip filters
Disables the IP filter for this profile.

active

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
active
Enable this VAP (VSC).
no active
Disable this VAP (VSC).

beacon dtim count

Supported on: MSM310 MSM320 MSM335 MSM410 MSM422
beacon dtim count <number>
Defines the DTIM period in the beacon.
Client stations use the DTIM to wake up from low-power mode to receive multicast traffic. The AP
transmits a beacon every 100 ms. The DTIM counts down with each beacon that is sent, therefore
if the DTIM is set to 5, then client stations in low-power mode will wake up every 500 ms (.5
second) to receive multicast traffic.
2-62
IP address.
Subnet mask in CIDR format. Specifies the number of bits in the mask.