Specifications; Setup - Drill Master 7" Variable Speed Polisher/Sander Owner's Manual & Safety Instructions

Specifications

Setup - Before use:
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO pRevent SeRiOuS injuRY FROm aCCiDental OpeRatiOn:
Release the trigger and unplug the tool from its electrical outlet before
assembling or making any adjustments to the tool.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
aSSemBlY
installing the auxiliary handles
tO pRevent SeRiOuS injuRY:
Do not operate this tool with one hand only or without the auxiliary handle(s) properly installed.
This Polisher/Sander includes two types of auxiliary handles. The D-Handle may be installed
for either right-hand or left-hand use. The Side Handle can be installed in one of three
positions on the head of the Polisher/Sander or together with the D-Handle.
Page 10
Electrical Rating
Motor No Load Speed
Max. Accessory Diameter
Spindle Thread
Accessories
(sold separately)
Figure a: handle installation Options
For technical questions, please call 1-800-444-3353.
120V~ / 60Hz / 10A
600-3500 RPM
7" (178 mm)
5/8" x 11 TPI
Backing Pad
Foam Pad
Polishing Bonnet
Sanding Discs
Item 69474