Table of Contents
Advertisement
Software Problems
Software Problems
Software controls printing feaures. Make sure you have selected the right driver in your software.
See your software documentation for more information.
Symptoms
Blank pages
appear between
printed pages.
Cannot get justified
right margin with a
proportionally
spaced font.
Control codes not
operating correctly.
Data sent to printer
does not print, but
DATA message
appears.
Data is sent to
printer, but nothing
happens. ON-LINE
message appears.
Symptoms
Last page of
document not
printed.
Problem
Number of lines per page in software
is not equal to number of lines per
page of printer.
Right justification with proportional
fonts is a software feature.
Incorrectly entered control codes.
A form feed has not been sent.
Wrong interface.
Problem
No form feed provided at end of
document.
Solution
Many software packages
assume 66 lines per page; your
printer default is 60. Adjust
software accordingly, or set
LINES/Pg in Menu 1 to equal
lines per page in software.
Check your software manual to
see if this feature is supported.
Check for confusion of letter l
with number 1, letter O with
number 0; make sure you are
using upper/ lower case
correctly; make sure font is
specified correctly and is
available.
Press the ON-LINE button to
take the printer off-line, then
press the FORM FEED button
to eject the final page, or send a
form feed command (decimal
character 12). If desired, set
AUTOEJCT in MENU2.
Select correct interface.
Solution
Press the ON-LINE button to
take the printer off-line, then
press the FORM FEED button
to eject the final page or send
the form feed code (decimal
character 12). If desired, set
AUTOEJCT in MENU 2.
Advertisement
Table of Contents
