Craftsman 315.349720 Operator's Manual page 25

TO CHANGEBLADEDEPTH
See Figure 27.
The blade depth should be set so that the outer points of
the blade are higher than the workpiece by approximately
1/8 in. to 1/4 in. but the lowest points (gullets) are below
the top surface.
• Raise the blade by turning the height/bevel adjust-
ing handwheel clockwise or lower it by turning the
handwheel counterclockwise
GULLET
Fig. 27
TO CHANGE BLADE ANGLE (BEVEL)
See Figured 28 - 29.
NOTE: A 90 ° cut has a 0° bevel and a 45 ° cut has a 45 ° bevel.
• Loosen bevel control by pulling the bevel locking lever
up.
• Tighten bevel control by pushing the bevel lock lever
down.
TO ADJUST THE BEVEL INDICATOR
See Figure 29.
If the bevel indicator is not at zero when the saw blade
is at 90 °, adjust the indicator by loosening the screw and
setting it at 0 ° on the bevel scale. Retighten the screw.
i'1
I
i r
SCREW
Fig. 29
TO INCREASE
ANGLE
TO DECREASE
ANGLE
Fig. 28
25