NUT
ARROWS
SCREW
LEGBRACE
Fig. 6
MOUNTING
THE TABLE SAW BASE TO THE
QUICKSTAND
R_
See Figure 8.
•
Place the table saw base on the leg stand. Position the
locking knob over the holes in the top of the leg stand,
•
Insert the screw on the locking knob into the hole and
turn the locking knob clockwise to secure the table
saw base to the leg stand,
•
Repeat with the other three locking knobs.
TO INSTALL
THE HANDLE
See Figure 9.
•
Hold the nylon nut securely and turn the screw counter-
clockwise to remove the nut completely,
NOTE- Do not remove the screw from the handle,
•
Place the nylon nut into the recessed hole on the back
of the height/bevel
adjusting handwheel and hold in
place,
•
Slide the screw, handle, and washer into the hole on
the height/bevel adjusting handwheel.
•
Using a flathead screwdriver, turn the screw clockwise
and tighten in place.
15
Fig. 7
i
I ,_
I
Fig. 8
SCREW
Fig. 9