Table of Contents
Advertisement
MAKING USER SETTINGS (cont.)
If you have not done so already, put your set-top into User Settings mode, as described on page 23.
The flow diagram on the right shows how you use the arrow, select, and power buttons on your set-top's front
panel to change the display and make the settings. See also the instructions below.
1. Press the D button until the front panel shows "reSt" (short for "restore factory settings"), as shown right,
and Restore Defaults is highlighted on the PACE USER SETTINGS menu.
2. Press the R button.
"YeS" appears on your set-top's front panel and the message: "Restore Default. Press OK to confirm" appears
on your TV screen. (If, at this stage, you no longer wish to restore the factory settings, press the L button.)
3. To confirm and restore the factory settings, press the select button.
The factory settings are restored, and the PACE USER SETTINGS menu reappears.
4. If you want to continue changing the settings, see the sections from page 23 onwards. If you have finished
changing the settings, press the power button. Your set-top then switches on with the restored settings.
If your set-top and HDTV are connected via a standard HDMI
about the required settings back to your set-top (see page 25). If you wish to restore your set-top's settings
to those created by your HDTV, you must disconnect your set-top from your HDTV before you restore the
factory default settings. When you reconnect your HDTV to your set-top via the HDMI
pass back the information again.
Always turn off your set-top, wait 60 seconds, then disconnect your set-top from the wall AC outlet before
you connect or disconnect any other equipment to or from its rear panel.
NOTES
cable, your HDTV may pass information
TM
cable, your HDTV will
TM
35
Advertisement
Table of Contents
