System Settings; User Accounts - Cisco WAP121 Administration Manual

Administration

System Settings

System Settings
STEP 1
STEP 2
STEP 3

User Accounts

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
The System Settings page enables you to configure information that identifies the
WAP device within the network.
To configure system settings:
Select Administration > System Settings in the navigation pane.
Enter the parameters:
• Host Name—Administratively assigned name for the WAP device. By
convention, the name is the fully qualified domain name of the node. The
default host name is wap concatenated with the last 6 hex digits of the MAC
address of the WAP device. Host Name labels can contain only letters, digits
and hyphens. Host Name labels cannot begin or end with a hyphen. No other
symbols, punctuation characters, or blank spaces are permitted. The Host
Name can be 1 to 63 characters long.
• System Contact—A contact person for the WAP device. The System
Contact can be 0 to 255 characters long and can include spaces and special
characters.
• System Location—Description of the physical location of the WAP device.
The System Location can be 0 to 255 characters long and can include
spaces and special characters.
Click Save. The changes are saved to the Startup Configuration.
One management user is configured on the WAP device by default:
• User Name: cisco
• Password: cisco
You can use the User Accounts page to configure up to four additional users and to
change a user password.
3
29