Table of Contents
Advertisement
Problem
Solution
Time/Day Stamp
•
Set the time clock (p, 5).
stuck at 12 a.m Mon.
Answers on t0th ring
•
Make sure answerer is turned on.
•
Memory is full See p. 14.
Incoming messages
•
Extension was picked up?
are incomplete
*
1 MIN time limit was exceeded, set to NO LIMIT. See
p. 5.
•
Memoryis full.
• Accidentally pressed PLAY button during playback
and stopped message.
Won't respond to
Must use tone-dial phone.
remote commands
Must enter correct security code. See pp. 15, 16.
Did unit hang up? If you take no action for a period
of time, it automatically han_lsup.
Answer function
Press the RESET button on the back of the base to
operates erroneously
reset unit.
or not at all.
Three horizontal bars
Erase messages. The memory is full. The unit's
(E_ appear in the display
memory holds 39 messages and 20 minutes of
messages and/or memos. When a caller leaves a
message when 39 messages are stored in memory,
the oldest message is automatically erased to make
room for the newest one.
CAUSES OF POOR RECEPTION
• Aluminum siding
Foil backing on insulation
Heating ducts and other metal construction that can shield radio
signals.
• You're too close to appliances such as microwaves, stoves,
computers, etc,
• Atmospheric conditions, such as strong storms
Base is installed in the basement or lower floor of the house.
Base is plugged into AC outlet with other electronic devices.
• Baby monitor is using the same frequency.
• Handset battery is low.
• You're out of range of the base.
Advertisement
Table of Contents
