GE 2-9795 User Manual page 22

HANDSET SOUND SIGNALS
Signal Meaning
Three long beeps or continuous beeps Page signal
A long warbling tone (with ringer on) Incoming call signal
One short beep every 9 seconds Battery Low
TROUBLESHOOTING GUIDE
TELEPHONE SOLUTIONS
Problem Solution
No dialtone • Check installation:
-- Isthe base power cord connected to a working
outlet?
-- Is the Phone-in-Use light on?
-- Is the telephone line cord connected to the base
unit and the wall jack?
• Connect another phone to the same jack;the
problem might be your wiring or local service.
• Is the handset out of range of the base?
• Make sure the battery is properly charged (12 hours).
• Is the battery pack installed correctly?
• Did the handset heap when you pressedthe PHONE
ON/OFF button? Did the Phone-in-Use light come
on? The battery may need to be charged.
• Reset the security code by placing the handset in the
base for about 20 seconds,
Io flashesin display Installnew9-volt battery.
Dialtone is OK, * Makesurethe PULSE/TONE switchon thebaseis
20