Fisher & Paykel DishDrawer DD603 User Manual page 19

FAULT CODES
DishDrawer
HOW TO RECOGNIZE A FAULT CODE
When a fautt code is displayed, the DishDrawer_"_wiL[
continuously beep every second until the POWER button
is pressed.
For Prefinished Models
A fautt code is indicated in the ELectronic DispLay, with a
spanner, Letter and a number beside it, for example,
"F1" or "U1 ".
For Integrated Models
A fautt has occurred when the LiBht above the START/PAUSE
button is red. The LiBhts on the wash proBram indicator
siBnaL which fautt code has occurred, for example,
a "F1" fautt code is
NOW TO ATTEND TO A FAULT CODE
1o Press the POWER b_/_ttonto remove the f:a_/_[t code°
2, If the f:au[t code and contin_4o_/_s beeps cap,not
be removed
by pressinf_ the POWER button_
b_rn the
power off: at the power
:;upp[yo
3o We
recommend
you check the _:hart below and
correct the f:au[t v/here
possib[eo
4, After
attendin[]
to the
f:au[t_
turn the
DishDrawe¢
on at the power
:;upp[yo
5, If the f:aul.t code and continuous
beeps remaffb
turn the water and power
supp[y
off: to the
DishDrawer o
._ HEAVY NORMAL FAST DELICATE RINSE I_ECO/)
Each faul.t code is Listed in the chart bel.ow for pref-inished
and inteBrated models.
your request°
_ULT CODE2
F1
F2
F3
F4
o__
U1
_NTEGRAT£E
_ _,,'j HEAVY NORMAL FAST DELICATE RINSE !l ECO
HEAVY NORMAL FAST OELICATE RINSE _CO/
_..- _ FAST DELICATE RINSE _E{ECO
1_ HEAVY NORMAL FAST DELICATE RINSE _tEGO '
POSSIBLE CA_JSE5
Flood switch has
been activated.
Motor problem.
Temperature sensor
failed.
Faulty temperature
sensor or element.
Electronics
malfunction.
..... c r _ _:_ _ ..... Fill fault.
HEAVY NORMAL FAST DELICATE RINSE ECO
Turn the Water and power
supply off to the DishDrawer _'
and call your Fisher and Paykel
Authorized Service Center.
Call your Fisher& Paykel
Authorized Service Center.
Ensure water €oming in through
the inlet hose is not greater
than t49 _F. You may need to
put a tempering _alve on your
water supp!y.
Call your Fisher & Paykel
Authorized Service Centre.
Call your Fisher & Paykel
Authorized Service Center.
®
Turn the D_shDrawer water
suppzyon.
Ensure the spray arm is on the
impeller The spruy arm must
be able to rotate about the
center If the DishDrawer is
full of water, the water will
need to be manually removed.
If you then have any questions about operating the product,
please contact our Fisher and Paykel Customer Care Center
17