Table of Contents
Advertisement
if you purchase
the optional
chest pulse sensor, follow the steps below to install the receiver included
with the chest pulse sensor.
1, Make sure that the key is removed from the con-
sole and that the power cord is unplugged.
Remove the indicated Screw (3) and the Access
Door (76) from the back of the Console Base (85),
2, Connect the wire on the receiver (A) to the indicated
wire extending from the ConsoUe Base (85), HoJd
the receiver so the small cylinder
is oriented
as
shown and is facing the Console
Back. Attach
the receiver to the pUastic posts on the Access Door
(76) with the two included small screws,
3, Make sure that no wires are pinched.
Reattach
the Access Door (76) with the Screw (3), Discard
the other wires included with the receiver,
Small
Screws
3 _
A
Small
Cylinder
Advertisement
Table of Contents
