Canon LEGRIA HFR16 Instruction Manual page 146

Back up recordings regularly
- This message may appear when you turn on the camcorder. In the event of a malfunction,
recordings may be lost so back up your recordings regularly.
Buffer overflow. Recording was stopped.
- The data transfer rate was too high for the memory card in use and the recording was
stopped. Replace the memory card with one rated Speed Class 2, 4, 6 or 10.
/ /
- The built-in memory could not be read. Contact a Canon Service Center.
/ /
- The built-in memory is full ([
( 50, 83) to free some space. Save your recordings (
memory ( 35).
/ /
- There is a problem with the built-in memory. Contact a Canon Service Center.
Cannot convert
- Cannot access the memory card. Check the memory card and make sure it is inserted cor-
rectly.
- You inserted a MultiMedia Card (MMC) into the camcorder. Use a recommended memory card
( 32).
- There was an error creating the file name. Set
tialize the memory card (
[For Web (MPEG-2)] and [For DVD (SD-VIDEO)] index screens (
/ /
- The total size of the scenes you selected to copy exceeds the available space on the memory
card. Delete some recordings on the memory card (
scenes to copy.
- The memory card already contains the maximum number of scenes (3,999 scenes). Delete
some scenes (
Cannot divide the scene. Initialize only using the camcorder.
- The scene could not be divided because the camcorder's internal scene management data log
is full. Save your recordings (
video files back to the memory and divide the scene again.
Cannot edit
- Could not move a scene in the playlist. Delete some scenes from the playlist (
Cannot enter standby mode now
- The camcorder cannot enter standby mode if the remaining battery charge is too low. Charge
or replace the battery pack (
146
Additional Information
Built-in memory error
Built-in memory is full
End] appears on the screen). Delete some recordings
Cannot access the built-in memory
35) or delete all the photos (
Cannot copy
50) to free some space.
104) and initialize the memory (
18).
104) and initialize the built-in
[Photo Numbering] to [Reset] and ini-
83) and all the scenes in the
44).
50, 83) or reduce the number of
35). Then, write the
73).