Emptying The Dust Cup; Cleaning & Changing The Hepa Dust Cup Filter - Euro-Pro Shark EP601 Owner's Manual

Warning: Alwaysunplugthe unit from
electricaloutlet beforeopeningthe Dust
Cup (container),
• Holdthe dust cup in your hand.
, Turn it a complete90° in the direction
shown in drawing#t (Turninglessthan
90° will causethe dust cup to be
attachedon itsbottom.)
• Let the dust cup comedown slightlyas
shown in drawing#2
° Slidethe dust cupout towardsyou (see
arrowin drawing#3).
, Holdthe dust cup in your handand
removethe HEPAdust cup filter (see
drawing#4).
o Emptythe dust cup (seedrawing#5)
Cleaninq & Chanqin_q the HEPA
Dust Cup Filter
,
After you have emptied the dust from
the Dust Cup (container), separate
the debris screen from the HEPA filter
cartridge by grasping the debris
screen with one hand and the filter
frame with the other and pull apart.
Debris Screen
HEPA Filter
2. Rinse the debris screen under the
faucet until clean, Allow to air dry or
dry with a clean dish towel Do NOT
wash in dishwasher.
3. To clean the HEPA filter cartridge,
hold filter by frame flange and tap
filter on the inside wall of a dust
container (garbage can)
• +
":d_>L
NOTE: Always turn off the power switch
and unplugthe electrical cord before
emptying the Dust Cup.
Ensure that you do not damage the
pleated filter material during cleaning.
Also note that discoloration occurs
during use.. This does NOT affect the
filter's performance.
4_ Reassemble the debris screen to the
HEPA filter cartridge and replace into
dust cup (container). Ensure that the
filter assembly is completely seated
inside the dust cup (container).
5. Attach the dust cup (container) to the
vacuum.
Important: Do NOT use the HEPA filter
cartridge without the debris screen in
place.
Warning:
Always empty the dust cup and clean the HEPA dust cup filter before
each use and during prolonged usage. Never over flit the dust cup - remove dirt and
clean the HEPA dust cup filter during prolonged usage or risk motor damage Make
sure that the debris screen is completely dry before reassembling the HEPA
Filter.
6