Table of Contents
Advertisement
Installation,
Connection
and Transport
Safety
information
The washing machine is heavy. Take care when
lifting it.
Frozen hoses can tear / burst. Do not install the
washing machine outdoors or in an area prone
to frost.
Be sure to observe all listed warnings and cautions.
These installation instructions are intended for use
by qualified installers. In addition to these
instructions the washer shall be installed:
In the United States, in accordance
with the
National Electric Code, ANSI/NFPA70
- latest
edition/State
and Municipal codes and/or local
codes.
In Canada, in accordance
with the Canadian
Electric Code C22.1 - latest edition/State
and
Municipal codes and/or local codes.
If the washing machine is located in a room which
will be exposed to freezing temperatures,
or if it is
located in a cabin that is being shut down for the
winter, any residual water in the pump or water inlet
hose(s) must be drained.
To drain the pump refer to page 20.
To drain the water hose(s) refer to page 22.
Take care not to damage the washing machine.
Do not hold onto protruding
parts (e.g. loading
door) when lifting.
In addition to the safety information
listed here, the
local water and electricity supplier may have special
requirements.
If in any doubt, have the appliance connected
by
an authorized technician.
Factory-supplied
equipment
There is a packet of accessory
parts supplied with
your washer. Check to make sure that the
accessory
parts supplied for your model are all
there. If any parts are missing, contact your dealer
immediately.
Inside the drum:
-
Water supply hoses (cold and hot water).
Any dampness
inside the drum is left over from final
testing which every washing machine is subjected
to before leaving the factory.
26
Hide quick links:
Advertisement
Table of Contents
