Motor Safety Filter C Hanging - Kenmore 116.21614 Use & Care Manual

MOTOR SAFETY FILTER C HANGING
The motor safety filter must be replaced when dirty, It should be replaced regularly
depending on use conditions. The filter CANNOT be washed as it will lose its dust trapping
ability.
NOTE: Use replacement motor safety filter STYLECF-1, see part number detail in
REPLACEMENTPARTS(page 5).
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner from
electrical outlet. Do not operate the
vacuum cleaner without the motor safety
filter. Be sure the filter is dry and properly
installed to prevent motor failure and/or
electrical shock.
1. Remove the bag
as outlined in the
BAG CHANGING
section (page 20).
2. Lift the rubber
retainer and pull out
motor safety filter
as shown.
3. Replace the filter,
white side facing
toward dust bag, by
sliding it back into
place under the ribs
in the bag cavity.
Tuck filter in so that
it fits completely
under the rubber
retainer.
4. Replace the bag as outlined in the BAG
CHANGING section (page 20).
-21 -