Kenmore 116.28014 Use & Care Manual page 21

TO
CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacu-
um cleaner, the agitator must be cleaned
every time the belt is changed.
The agitator must also be cleaned accord-
ing to the following schedule:
Vacuum Cleaner Use Clean Agitator
HEAVY - every week
(used doily)
MODERATE - every month
(used 2-3 times/week)
LIGHT - every 2 months
(used ] time/week)
IMPORTANT
Turn off and unplug vacuum cleaner from
electrical outlet. Check and remove hair,
stringand lint build-up frequently in the
PowerMate agitator and end cop areas.
Remove any dirt or debris in the belt path
area or in the brush roller area.
Carefully remove any string or debris
located on the agitator or end caps.
AGITATOR ASSEMBLY
-End Cap _nn_ ....... n n_ Belt Path_
,°0d
TO REPLACE BELT
1. Install new
belt over
motor drive,
then over
belt path.
for
ire
\ \ Path
Agitator End Cap
NOTE: See PARTS AND FEATURES for Belt
number.
2. Place agitator
assembly back
into PowerMate.
agitator
cover and
replace two
(2) screws.
4. Line up front of cover and base. Rest
cover on front edge of base as shown.
5. Rotate
cover back.
Press cover
firmly until side
latches snap
into place.
Make sure there is no gap between the
cover and base.
6. Turn PowerMateupside down and
replace five (5) cover screws.
Z Insert floor
brush into
PowerMate until
floor brush locks
into place.
-21 -