Cooking Zones - Kenmore 911.46765 Owner's Manual

o Do not slide cookware acrossyourcooktop.
_' Do not use a dish towel or sponge to clean
or wipe down .your cooktop.
o Do not use scouring powders or plastic,
nylon or metal cleaning pads on your
cooktopo
o Do not applyyour cooktop cleaning creme
to the cooktop surface if the surface is hot.
o Read the instruction label on the cooktop
cleaning creme bottle before attempting to
clean the surface of your cooktop.
o Aftercleaning the cooktop surface, be sure
to wipe off any residue that may be teft from
the creme with a dry paper towel.
o For major spills, turn the surface control
knob to LO; use a dry paper towel to wipe
up spill, then use a razor scraper (held with
a pot holder) at a 30 ° angle against the
surface of the cooktop to scrape remaining
spill from the hot cooking zone.
o Do not cook directly on the surface of the
glass.
o Do not use the cooktop as a cutting board.
............................... CAUTION: When the surface _
_ controls are turned off, the Hot
Surface Indicator light will
remain lit until the cooktop
surface has cooled to approximately
150°F. The glass ceramic surface will
retain heat after the indicator light goes
out. Use caution until the cooktop
surface has had time to cool.
To remove the adhesive left from packaging
tape, use household dishwashing liquid,
mineral oi! or cooking oil. With a soft cloth rub
into the area and allow to soak. Rinse and dry
well. Repeat procedure using an appliance
polish to insure no damage is done to the
oven° This should be done before the
range is turned on for t_e first time.
The tape cannot be removed once tl_e
oven has keated.
Packaging tape can be found in the
following areas:
Cooktop surface
Doorhandle
Con trol panen area
Door trim
Oven area
6