To Remove The Freezer Door - Frigidaire 242108503 Use & Care Manual

DOOR REMOVAL INSTRUCTIONS
3 Remove the two bottom hinge screws and
hinge if necessary.
Hinge
Assembly
Screws
Adjustable Hinge
To reinstall the refrigerator door, reverse the
above steps.
To remove the freezer top hinge
cover:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift hinge cover straight up and off.
Front
Cover Screws
Top Hinge
Cover
Hinge
Screws
Multi-Wire
Cable

To remove the freezer door:

1 Detach the multi-wire cable connector
located above the top hinge. Grasp both
sides of the connector firmly and pull apart.
8
Door
Closer
Pin
Hinge
Rear
Cover
Screw
Top
Hinge
2 Trace lightly around the hinge with a
pencil. This makes reinstallation easier.
3 Detach the water tube from the connector
located below the freezer door. The
connector releases when you press its
outer sleeve inward.
4 Remove the screws from the top hinge
and pull the multi-wire cable through it.
Lift the door off of the bottom hinge.
5 Remove the two bottom hinge screws and
hinge if necessary.
To Disconnect
1. Press outer ring against face
of fitting
2. Pull to
remove tube
To Connect
Insert tube and
push until mark touches face of fitting
Closer
Pin
Hinge
Adjustable Hinge (some models)
Hinge
Assembly
Non-Adjusting Hinge (some models)
6 Lay the door on its side to avoid damage
to the water tube extending from the
bottom hinge.
To reinstall the freezer door, reverse the above
steps.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury.
Door
Water
Line
Tubing
Hinge
Assembly Screws
Door
Water
Line
Tubing
Screws