Handle Installation - Frigidaire 242108503 Use & Care Manual

CAUTION
Wear gloves and safety goggles and
use extreme CAUTION when installing
these handles. The rounded end of
the handles may be sharp (some
models).
IMPORTANT
To ensure proper installation of
handles, please review these
instructions and illustrations
thoroughly prior to installing the
handles.
1 Remove handles from carton and
any other protective packaging.
2 Position freezer handle end caps
over upper and lower pre-installed
shoulder bolts (A) that are fastened
into door, ensuring the holes for the
set screws are facing towards the
refrigerator door.
3 While holding handle firmly against
door, fasten upper and lower Allen
set screws (B) with supplied Allen
wrench.
4 Repeat steps 2 and 3 to install
refrigerator handle. Ensure the
holes for the set screws are facing
towards the freezer door.

NOTE
All set screws should be tightened
and sub-flush (Allen set screw should
be seated just below the surface of
the end cap) of handle end cap. The
end caps should be drawn tight to
freezer and refrigerator doors with
no gaps.
Ensure Handle Set Screws
are Facing Each Other
with Doors Closed

HANDLE INSTALLATION

Frigidaire Professional
Freezer Upper
End Cap
Freezer Lower
End Cap
Frigidaire Gallery
Freezer Upper
End Cap
Freezer Lower
End Cap
®
Refrigerator Upper
End Cap
Refrigerator Lower
End Cap
®
Refrigerator Upper
End Cap
Refrigerator Lower
End Cap
9