Whirlpool W10150593A Installation Instructions Manual page 5

Straight power cord
Straight power cord
1. Remove power plug and yellow strap from machine base to
release the rear leveling system.
2. Firmly grasp the power cord and pull to completely remove
the power cord, cord restraint, and pin from the rear panel.
3. Confirm that the power cord restraint (A), and pin (B) are
removed.
A
A. Power cord restraint
4. To remove the power cord from the cord restraint, push the
power cord in, press TAB, and then pull the power cord out.
B
B. Pin
Looped power cord
Looped power cord
1. Firmly grasp the yellow shipping strap and pull until both ends
are completely removed from washer.
2. Check that two (2) shipping pins were removed with the
shipping strap.
5