Trane XT302C Installer's Manual page 6

XT302C DELUXE PROGRAMMABLE HEAT-COOL THERMOSTAT
Press Time
or
Installer
Setup Number
Select
Adaptive 13
Intelligent
Recovery™
control
Degree 14
temperature
display
Clock format 16
Extended fan 19
operation in
a
heating
Extended fan 20
operation in
cooling
Outdoor 24
temperature
display (select
models)
Comfort-R 28
Enable
Minimum 30
Deadband
Between
Heating and
Cooling in Auto
Changeover
Mode
Minimum On 32
Time (Heat)
Pub. No. 18-HD25D7-5
69-1213—1 (T8624)
Table 3. Installer Setup Options for the XT302C (continued).
Press Increase
Factory Setting
Display Description
0 Adaptive Intelligent
Recovery (a
Honeywell trademark)
control is activated
(system starts early so
setpoint is reached by
start of program
period)
0 Temperature displays
in F
0 12-hour clock format
0 No extended fan
operation after the call
for heat ends
0 No extended fan
operation after the
call for cool ends
0 No outdoor
temperature displays
0 No fan delay
4 Heating and cooling
setpoints can be set
no closer than 4 F
(2 C)
5 5-minute minimum on
time for compressor
or Decrease to change setting
Other Choices
Display
1 Conventional recovery
(system starts recovery at
programmed time)
1 Temperature displays in C
1 24-hour clock format
1, 2 or 3 1—Fan operation extends
30 seconds after the call
ends.
2—Fan operation extends
60 seconds after the call
ends.
3 —Fan operation extends
90 seconds after the call
ends.
1, 2 or 3 1—Fan operation extends
30 seconds after the call
ends.
2—Fan operation extends
60 seconds after the call
ends.
3 —Fan operation extends
90 seconds after the call
ends.
1 Outdoor temperature
displays. Requires a
TAYSENS100A Outdoor
Sensor.
1 or 2 1—30 seconds
2—15 seconds
3 thru 10 Heating and cooling
setpoints can be set no
closer than the chosen
value:
3—3 F (1.5 C)
4—4 F (2 C)
5—5 F (2.5 C)
6—6 F (3 C)
7—7 F (3.5 C)
8—8 F (4 C)
9—9 F (4.5 C)
10—10 F (5 C)
0 thru 15 Minimum number of minutes
(0 thru 15) the compressor
will be on during call for
heat
6
Actual
Setting
Description
(continued)