Troy-Bilt 5210R Owner's/Operator's Manual page 10

EASY ASSEMBLY
)
B~
Figure 2-1
Step 1: Attach the Handlebars.
1. Remove the four loosely installed 5/16-18 x 7/8
flange screws from holes A.
2. Place the lower ends of the handlebar assembly
on the outside of the upper rear corner of the
frame as shown in Figure 2-1 (Item A). Align the
two holes in the left side of the lower end of the
handlebars with the two holes in the left side of
the frame.
3. Loosely install a 5/16-18 x 3/4 hex flange screw
into each of these holes.
4. Repeat the previous two steps for the right side of
the lower handlebars.
5. Evenly tighten all four screws.
6. Use the two 7/16-inch wrenches to check the four
handlebar control panel mounting screws (Figure
2-1, Item CC) for tightness.
Step 2: Connect the Ignition Ground
Wires
1. Run the black ignition ground wire down the left-
hand handlebar tube as shown in Figure 2-1 and
2-2 (Item B).
2. Plug the connector at the lower end of the black
ignition ground wire into the terminal beneath the
Engine Control Lever. See Figure 2-1 (Item B).
3. Attach the black ground wire
to the lower left handlebar
with the two tie straps. See
N
Figure 2-1 and 2-2 (Item C).
Figure 2-2
8