Advertisement
Chapter 2
Installation
•
All ports will lose their VLAN assignment and will be reassigned to
Generic VLAN.
•
The Administration Status of all P110 switches will be Enabled. In order
to avoid any possible loops, any port that you disabled using the
management software must be physically disconnected before software
download. Once you have downloaded the new software, set the port to
disabled again and then reconnect the cable.
6. Place the P114T and any other additional P110 hubs at the bottom of the stack.
7. Connect P110 hubs using the supplied P110 Exoplane cables, as shown in
Figure 2. A hub connects to its upper neighbor through two Exoplane cable,
and to its lower neighbor through another two Exoplane cables.
Make sure that the P110 Exoplane cables are correctly seated by gently
exerting pressure on the back of the connector.
Cabling Requirements:
•
For correct operation, the P110 Exoplane must be fully connected, with all
units powered up. In case units are stacked, the P110 NMA must be installed
and connected to the P110 Exoplane.
Failure to observe this requirement will cause the units to block all traffic on
attached stations and segments.
•
When using the P114T or P114F in the stack, make sure all switches in the
stack are connected using P110 Exoplane cables with white connectors and
marked C/S:B (part number 108362203). Extra cables can be ordered from
your local Avaya representative.
Figure 2
8
Rear view of a P110 switch stack, showing how the switches are linked via
the P110 Exoplane cables. A P110 NMA resides in the uppermost switch.
P114T Stackable Switch Installation Guide
Advertisement
