Sears kenmore Vacuum Cleaner Owner's Manual page 17

5. Carefully
insert and
twist
screwdriver
at each
brush
support to
free brush
from base.
& Remove worn
belt.
7. Slide brush
supports off to
check and ctean
brush support
areas. See BRUSH
ASSEMBLY for
picture of
complete brush
assembly
TO REPLACE BELT:
sprocket.
NOTE:See PARTS
AND FEATURES
for Belt #.
1. Slide washers and brush supports onto brush
assembly.
\\\ ",_-. A
2. Install new belt _-__'
over motor drive,
then over brush
Motor
t Brush Sprect_t
Bt_sh Support
3. Snap brush
SUPborts into place
on base, Be sure
brush supports are
not upside-down,
4. Line up front of
cover and base,
Rest cover on front
edge of base as
shown,
5. NOTE:
Be sure that the
board is upright
and the wires are
tucked back as
shown,
B_
6. Ti!t cover to
back, Press cover
firmly until side tabs
snap into place.
Repiace cover
screws, light bu!b
and light cover,
17